Revit Families – Doors
Last updated March 25, 2025
By Ian Story
Stacking Levels for Symbolic Representations
To make sure symbolic elements (Masking Regions and Symbolic Lines) stack in the right order, set the highest points in nested door families as follows. We typically use a vertical invisible model line to set the height.
- Door Swings: 10″ above R.O.
- Door Units: 10″ above R.O.
- Door Frames: 9.5″ above R.O.
- Door Casings: 9″ above R.O.
- Door Opening Mask: 0″ above R.O.
Commentary
This is a long block of text that will be used for testing. This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.This is a long block of text that will be used for testing.
Recent Posts
Categories
- Accessibility (2)
- Annotation Templates (1)
- Building Code (5)
- Calculation Templates (2)
- Civil Engineering (3)
- Derivations (8)
- Drafting Standards (17)
- Geotechnical Engineering (1)
- IT & Software Setup (5)
- Product Knowledge (9)
- Production Tutorial (7)
- Research Notes (9)
- Research Tips (1)
- Revit Families (2)
- Revit Tips (5)
- Standard Operating Procedures (5)
- Stormwater (4)
- Structural Calculators (4)
- Structural Engineering (29)
- Structural General (11)
- Uncategorized (30)